User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Administering Your Cisco RV110W
Restarting the Cisco RV110W
Cisco RV110W Administration Guide 134
7
Restarting the Cisco RV110W
To restart the router:
STEP 1 Choose Administration > Reboot.
STEP 2 Click Reboot.
Restoring the Factory Defaults
!
CAUTION During a restore operation, do not try to go online, turn off the router, shut down the
PC, or use the router until the operation is complete. This should take about a
minute. When the test light turns off, wait a few more seconds before using the
router.
To restore factory defaults to the router:
STEP 1 Choose Administration > Restore Factory Defaults.
STEP 2 Click Default.
Running the Setup Wizard
To run the Setup Wizard:
STEP 1 Choose Administration > Setup Wizard.
STEP 2 Follow the online instructions.