User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
6
Cisco RV110W Administration Guide 111
Configuring Quality of Service (QoS)
The Cisco RV110W lets you configure the following Quality of Service (QoS)
features:
• Configuring Bandwidth Management, page 111
• Configuring QoS Port-Based Settings, page 113
• Configuring CoS Settings, page114
• Configuring DSCP Settings, page 114
Configuring Bandwidth Management
You can use the Cisco RV110W bandwidth management feature to manage the
bandwidth of the traffic flowing from the secure network (LAN) to the insecure
network (WAN).
Configuring Bandwidth
You can limit the bandwidth to reduce the rate at which the Cisco RV110W
transmits data. You can also use a bandwidth profile to limit the outbound traffic,
thus preventing the LAN users from consuming all of the bandwidth of the Internet
link.
To set the upstream and downstream bandwidth:
STEP 1 Choose QoS > Bandwidth Management.
STEP 2 In the Bandwidth Management field, check Enable. The maximum bandwidth
provided by your ISP appears in the Bandwidth section.