User Manual
Table Of Contents
- Introduction
- Configuring Networking
- Configuring the Wireless Network
- Configuring the Firewall
- Configuring VPN
- Configuring Quality of Service (QoS)
- Administering Your Cisco RV110W
- Setting Password Complexity
- Configuring User Accounts
- Setting the Session Timeout Value
- Configuring Simple Network Management (SNMP)
- Using Diagnostic Tools
- Configuring Logging
- Configuring Bonjour
- Configuring Date and Time Settings
- Backing Up and Restoring the System
- Upgrading Firmware or Change the Language
- Restarting the Cisco RV110W
- Restoring the Factory Defaults
- Running the Setup Wizard
- Viewing the Cisco RV110W Status
- Using Cisco QuickVPN
- Where to Go From Here
Configuring VPN
Configuring VPN Passthrough
Cisco RV110W Administration Guide 109
5
Exporting Certificates for Admin
The certificate for administrator contains the private key and should be stored in a
safe place as a backup. If the Cisco RV110W configuration is reset to the factory
default settings, this certificate can be imported and restored on the router.
To export a certificate for Admin:
STEP 1 Choose VPN > Certificate Management..
STEP 2 Click Export for Admin.
On a PC, the Device Manager saves the admin.pem file in the C:\Documents and
Settings\userid\My Documents\Downloads.
Exporting Certificates for Client
The certificate for client allows QuickVPN users to securely connect to the
Cisco RV110W. QuickVPN users must place the certificate in the install directory
of the QuickVPN client.
To export a certificate for client:
STEP 1 Choose VPN > Certificate Management..
STEP 2 Click Export for Client.
On a PC, the Device Manager saves the client.pem file in the C:\Documents and
Settings\userid\My Documents\Downloads.
Configuring VPN Passthrough
VPN passthrough allows VPN traffic that originates from VPN clients to pass
through the Cisco RV110W.
To configure VPN passthrough:
STEP 1 Choose VPN > VPN Passthrough.
STEP 2 Choose the type of traffic to allow to pass through the firewall: