User guide

Chapter 4
Advanced Configuration
36
10/100 8-Port VPN Router
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
NOTE: The content filter rules will be
automatically disabled if the Trend Micro
ProtectLink service is activated on the Router.
ProtectLink
For information about the ProtectLink tab, refer to
“Appendix G: Trend Micro ProtectLink Gateway Service”.
VPN > Summary
This screen displays general information about the
Router’s VPN tunnel settings. The Router supports up to
100 tunnels.
VPN > Summary
Summary
Tunnel Used The number of VPN tunnels being used is
displayed.
Tunnel Available The number of available VPN tunnels
is displayed.
Detail Click Detail for more information.
VPN Summary Details
The WAN1 IP address and WAN2 IP address will be
displayed.
For each VPN tunnel, the No., Name, Status, Phase 2 Enc/
Auth/Grp, Local Group, Remote Group, and Remote
Gateway will be displayed.
For each group VPN, the Group Name, number of
Connected Tunnels, Phase 2 Encrypt/Auth/Group, Local
Group, and Remote Client will be displayed.
Click Close to exit this screen and return to the Summary
screen.
Tunnel Status
Add New Tunnel Click Add New Tunnel to add a VPN
tunnel. The Mode Choose screen appears.
Mode Choose
Gateway to Gateway
To create a tunnel between two VPN devices, such as two
VPN Routers, click Add Now. The Gateway to Gateway
screen appears. Proceed to the “VPN > Gateway to
Gateway” section for instructions. Click Return to return
to the Summary screen.
Client to Gateway
To create a tunnel between the VPN Router and the client
using VPN client software that supports IPSec, click Add
Now. The Client to Gateway screen appears. Proceed to the
“VPN > Client to Gateway” section for instructions. Click
Return to return to the Summary screen.
If the VPN Summary table has multiple pages, select a
different page to view from the Jump to drop-down menu.
If you want more or fewer entries listed per page, select
a different number from the entries per page drop-down
menu.
After you have added the VPN tunnel, you will see it listed
in the table.
No. It shows the number of the VPN tunnel.