User guide

Chapter 4
Advanced Configuration
25
10/100 8-Port VPN Router
Generate the Error Condition in the System •
Log Failover will not occur; only an error condition
will be logged.
Network Service Detection can test a WAN port’s network
connectivity by pinging the Default Gateway or a specific
IP address.
WAN1/2
Default Gateway Select this option to ping the Default
Gateway.
ISP Host Select this option to ping the ISP Host. Then
enter the IP address.
Remote Host Select this option to ping the Remote Host.
Then enter the IP address.
DNS Lookup Host Select this option to ping the DNS
Lookup Host. Then enter the IP address.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
Load Balance
System Management > Dual-WAN > Load Balance
Network Service Detection
Enable Network Service Detection Network Service
Detection helps manage your connection and can report
when your connection experiences problems. To use this
service, select this option.
Retry Count Enter the number of times the Router will
try to reconnect if the connection fails.
Retry Timeout Enter the number of times the Router will
try to make a connection to your ISP before it times out.
When Fail Should the connection not be reestablished,
set the Router to perform one of the following actions,
Remove the Connection or Generate the Error
Condition in the System Log.
Network Service Detection can test this connection by
pinging the Default Gateway or a specific IP address.
WAN1/2
Default Gateway Select this option to ping the Default
Gateway.
ISP Host Select this option to ping the ISP Host. Then
enter the IP address.
Remote Host Select this option to ping the Remote Host.
Then enter the IP address.
DNS Lookup Host Select this option to ping the DNS
Lookup Host. Then enter the IP address.
Bandwidth
WAN1/2
Upstream Enter the maximum upstream bandwidth
provided by your ISP. The default is 512 kbit/sec.
Downstream Enter the maximum downstream
bandwidth provided by your ISP. The default is
512 kbit/sec.
Protocol Binding
Service Select the Service you want.
If the Service you need is not listed in the menu, click
Service Management to add the new service. The Service
Management screen appears.
Service Management