Specifications

Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers 25
Checking the Installation
RSP7010#sho env all
Arbiter type 1, backplane type 70x0 (id 5)
Power supply #1 is 600W AC (id 1)
Active fault conditions: none
Active trip points: none
01234
Dbus slots: X X
card inlet hotpoint exhaust
CI(4) 22C/71F 34C/93F 24C/75F
Shutdown temperature source is 'hotpoint' on CI(4),
requested CI(4)
+12V measured at 12.31
+5V measured at 5.17
-12V measured at -11.89
+24V measured at 23.78
+2.5 reference is 2.49
If after several attempts, any component does not appear to be functioning properly, or if you
experience trouble with the installation (for instance, if the holes in the board do not align with the
backplane holes), contact a service representative or the Technical Assistance Center (TAC). (For
the TAC phone number and email address, refer to the note at the end of this document.
This completes checking the RSP7000CI installation, and also completes the RSP7000 upgrade kit
installation.