Specifications

OL-4923-01 B0

Booting Router-confg ..... [timed out]

Step 9 If the display indicates that the process was successful, as shown in Step 8, proceed to the Step 10.

If the display indicates that the process failed, verify the name or address of the remote server and the

filename, and repeat the preceding steps. If you are unable to retrieve the configuration file, contact your

network administrator or see the end of this document for instructions on contacting technical assistance.

Step 10 To ensure that the configuration file was retrieved correctly, issue the show startup-config command

and look at the first line for the configuration file size. Match it with the file you retrieved from the TFTP

server. Following is an example:

Router# show startup-config

Using 1186 out of 126968 bytes

version 11.1

hostname Router

Router#

Step 11 Ensure that the startup configuration file stored in NVRAM is the default running configuration file used

by the system, and then enter the copy startup-config running-config command as follows:

Router# copy startup-config running-config

Router#

%SYS-5-CONFIG_I: Configured from memory by console

Router#

This completes the procedure for retrieving the saved configuration file.

Replacing and Upgrading DRAM SIMMs

This section describes how to remove and replace RSP2 DRAM SIMMs.

The default DRAM configuration is 32 MB, residing on two SIMMs (U33 and U21) on Bank 0. The

DRAM SIMM sockets are U33 and U21 (bank 0), and U12 and U4 (bank 1). (See Figure 2 and Table 13.)

Note Do not mix memory sizes. If installing two SIMMs, both SIMMs must be the same size. If your router

includes redundant RSPs, both RSPs should have the same memory size.

Note The total number of memory devices per SIMM differs for each manufacturer. The SIMMs in Figure 2

are generic representations of the actual DRAM SIMMs for your RSP.

Table 13 lists the various configurations of DRAM SIMMs that are available, the number of SIMMs for

each configuration, and the DRAM banks they occupy. Note which banks are used, given the

combinations of available SIMM sizes and the maximum DRAM you require.