Specifications

3-17
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
Quickstart Provisioning Procedures
Step 3
addport
or
addimagrp
addimalnk
addimaport
Related commands:
dspports
or
dspimagrp
dspimagrps
dspimalnk
dspimalnks
dspimaport
dspimaports
Configure the local routing switch port that leads to the feeder. When
configuring the line, select either interface type 1 (UNI) or 2 (NNI).
Use the same interface type when defining the port on the feeder.
For standard port configuration, see the “Adding ATM Ports” section
on page 3-27.
To configure ATM communications over an IMA group, see the
“Configuring Inverse Multiplexing over ATM” section on page 3-33.
Step 4
cnfpart
Related commands:
dspparts,
dsppart
Assign trunk resources to the PNNI controller ID, which is 2.
Note When you add a port, a partition is automatically added. Use
the cnfpart com m and to change the configuration of a resource
partition.
See the “Partitioning Port Resources between Controllers” section on
page 3-40.
Step 5
cc Change to the PXM card.
Step 6
dnpnport <portid> Bring down the port so it can be configured.
Note The port must be down to use cnfpnportsig. The port should be
down by default. You can use dsppnport to see if the port is
down. If it is not down, use dnpnport to take the port down.
Step 7
cnfpnportsig
cnfoamsegep no
uppnport
Related commands:
dsppnports
dsppnport
dsppnportsig
Define the signaling protocol used on the trunk. If CWM will be used
to manage the feeder, enter the cnfpnportsig command to enable IP
communications between the switch and the feeder.
MGX8850.7.PXM.a > cnfpnportsig < portid > -cntlvc ip
Use the cnfoamsegep command to define the local routing switch
feeder port as a non-OAM segment endpoint. This is required to enable
testing with the tstdelay command.
See the “Selecting the Port Signaling Protocol” section on page 3-44.
Step 8
cc Change back to the AXSM card.
Step 9
addfdr
Related commands:
dspfdr
Define the local routing switch port as a feeder port.
See the “Defining a Feeder Port” section on page 3-58.
Command Comments