Specifications

3-11
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
Quickstart Provisioning Procedures
Step 3
Add a channelized path:
upln
cnfpath
uppath
Related commands:
dsppath
dsppaths
This step is for for AXSM-XG cards only. Otherwise, skip to
Step 4.
Add, configure, and bring up a channelized path. Do this step only
if you are configuring a virtual trunk on an AXSM-XG card. See
the “Channelizing SONET, SDH, and DS3 (T3) Lines into Paths”
section on page 2-17.
Step 4
addport
or
addimagrp
addimalnk
addimaport
Related commands:
dspports
or
dspimagrp
dspimagrps
dspimalnk
dspimalnks
dspimaport
dspimaports
Add and configure the virtual trunk end ports at the private
switches. This step establishes ATM communications between two
ATM devices.
Select interface type 3 for VNNI.
For standard port configuration, see the “Adding ATM Ports”
section on page 3-27.
To configure ATM communications over an IMA group, see the
“Configuring Inverse Multiplexing over ATM” section on
page 3-33.
Step 5
cnfpart
Related commands:
dspparts
dsppart
Configure trunk resources to PNNI and MPLS controllers. This
step can assign all the trunk bandwidth to one controller, or it can
assign portions of the trunk bandwidth to each controller.
Note When you add a port, a partition is automatically added.
Use the cnfpart command to change the configuration of a
resource partition.
See the “Partitioning Port Resources between Controllers” section
on page 3-40.
Step 6
cc Change to the PXM card.
Step 7
dnpnport <portid> Bring down the port so it can be configured.
Note The port must be down to use cnfpnportsig. The port
should be down by default. You can use dsppnport to see
if the port is down. If it is not down, use dnpnport to take
the port down.
Command Comments