Specifications

3-4
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
Quickstart Provisioning Procedures
Step 4
addport
or
addimagrp
addimalnk
addimaport
Related commands:
dspports
or
dspimagrp
dspimagrps
dspimalnk
dspimalnks
dspimaport
dspimaports
Add and configure ATM ports. This step establishes ATM
communications between two ATM devices.
Specify NNI for interswitch trunks.
For standard port configuration, see the “Adding ATM Ports”
section on page 3-27.
To configure ATM communications over an IMA group, see the
“Configuring Inverse Multiplexing over ATM” section on
page 3-33.
Step 5
cnfport
Related commands:
dspports
dspports
Use this optional step if you need to make changes to the port
created in the previous step.
For more information on modifying ports, see the “Adding ATM
Ports” section on page 3-27.
Step 6
cnfpart
Related commands:
dspparts
dsppart
Configure trunk resources to PNNI and MPLS controllers. This
step can assign all the trunk bandwidth to one controller, or it can
assign portions of the trunk bandwidth to each controller.
Note When you add a port, a partition is automatically added.
Use the cnfpart com m and to change the configuration of a
resource partition.
See the “Partitioning Port Resources between Controllers” section
on page 3-40.
Step 7
cc Change to the PXM card.
Step 8
dnpnport
cnfpnportsig
uppnport
Related commands:
dsppnports
dsppnport
dsppnportsig
Define the signaling protocol used on the trunk. Specify pnni10
for PNNI trunks.
See the “Selecting the Port Signaling Protocol” section on
page 3-44.
Note The port must be down to use cnfpnportsig. The port
should be down by default. You can use dsppnport to see
if the port is down. If it is not down, use dnpnport to take
the port down.
Step 9
Configure the other end of the link. If the other end of the link is
connected to another AXSM card, repeat Step 1 through Step 8.
If the other end of the link is on a different card type, refer the
documentation for that card.
Command Comments