Specifications

3-3
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
Quickstart Provisioning Procedures
Tip You can get configuration information for any command by entering the command without parameters
in the CLI.
Quickstart Provisioning Procedures
The sections that follow present abbreviated procedures that you can use to configure lines and provision
connections. To do the procedures in this section, you must start a CLI session on the appropriate AXSM
card by logging in with the appropriate username and password. For detailed information about user
names, passwords, and logging into the CLI, refer to the Cisco MGX 8800/8900 Series Configuration
Guide, Release 5.2.
Note The procedures in this chapter require you to log in as a user with GROUP1 privileges or higher.
MPLS and PNNI Trunk Configuration Quickstart
The following quickstart procedure summarizes how to configure an ATM trunk with MPLS and PNNI
partitions. An ATM trunk is a Network-to-Network Interface (NNI) that connects switches in the core of
the network.
This procedure must be completed on the switches at both ends of the trunk. After you configure an ATM
trunk, the trunk is ready to support SVCs, SPVCs, and SPVPs. (See the “SVC Configuration Quickstart”
section on page 3-7 or “SPVC and SPVP Configuration Quickstart” section on page 3-8 for more
details.)
Note The trunk configuration is not complete until the following procedure has been completed on the
switches at both ends of the trunk.
Command Comments
Step 1
username
<password>
Start a configuration session.
To perform all the steps in this quickstart procedure, you must log
in as a user with GROUP1 privileges or higher.
Step 2
cc Change to an AXSM card.
Step 3
Follow the steps in the “Preparing
AXSM Lines for Communication”
section on page 2-1
Bring up AXSM lines.