Specifications

Index
IN-7
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
COSB parameters 4-8, 4-16
COSB threshold parameters 4-9, 4-25
definition of 2-6
displaying a card SCT 4-4
displaying a port SCT 4-10
displaying card SCT settings 4-6, 4-11
general SCT parameters 4-7, 4-12
introduction 2-6
modify with CWM 2-7
port 2-6
selecting a port SCT 2-10, 4-11
virtual circuit threshold parameters 4-8, 4-19, 4-30
SCTs
port
displaying virtual circuit Frame Relay
parameters
4-31
SCTs for AXSMs 5-40
SDH lines
channelization
2-23
SDH paths
bringing up
2-25
Service Class Templates
See SCT
sesntimeout command
4-2, 5-435, 5-450
sesnwatchdog command 4-2, 5-436
seteng command 4-2, 5-437
setsctver command 1-9, 5-438
sfmDBShow command 4-2, 5-439
shellConn command 4-2, 5-441
showsyserr command 4-2, 5-442
signaling, configuring ILMI signaling 3-48
smclrscrn command 4-2, 5-443
soft permanent virtual circuits
See SPVC
SONET lines
channelization
2-21
SONET paths
bringing up
2-22
SPVC 3-8, 3-54
configuration 3-54
configuring master side 3-56, 4-47
configuring slave side 3-55, 3-58
SPVP 3-54
configuring master side 3-56, 4-47
configuring slave side 3-55, 3-58
startbert command 1-11, 5-444
startimalnktest command 5-445
startimalnktst command 1-13
static ATM addresses
adding
3-46
static link 3-61
stopbert command 1-11, 5-446
stopimalnktest command 5-447
stopimalnktst command 1-13
STS-1 paths 2-18
switchapsln command 1-11, 5-448
syserr command 4-2, 5-449
T
timeout command 1-8, 4-2, 5-450
trace command 4-2, 5-451
traps, configuring ILMI traps 3-48
trunks
AINI link configuration
3-20
BPX PNNI trunk configuration 3-18
bringing up 2-10
configuration 2-12, 2-14
MPLS configuration 3-1
PNNI configuration 3-1
viewing configuration 2-14
tstconseg command 1-15, 4-50, 5-452
tstdelay command 1-15, 3-17, 3-18, 3-46, 4-51, 5-454
TU-12 paths 2-18
TUG-3 2-18