Specifications

5-461
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
upilmi
upilmi
Up ILMI—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Use upilmi to activate interim local management interface (ILMI) for a particular resource partition on
a logical port. Before executing upilmi for the partition, you must:
1. Activate a line through the upln command and configure the line through cnfln
2. Create a logical port through the addport command
3. Add resource partitions through addrscprtn
After activating ILMI, you can configure ILMI though the cnfilmi command.
Syntax
upilmi <ifNum> <partId>
Syntax Description
Related Commands
cnfilmi, dspilmi
Attributes
Example
M8950_DC.14.AXSM.a > upilmi 21 1
Warning: connections (if any) on port could get rerouted.
Do you want to proceed (Yes/No) ? y
ifNum The logical interface (or AXSM port) number. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
partId The ranges for partition identifier are as follows:
• AXSM: 1–5
• AXSM-E, AXSM-XG: 1–20
Log: yes State: active, standby Privilege: GROUP1