Specifications

5-452
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
tstconseg
tstconseg
Test Connection Segment—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Test the integrity of an SVC or SPVC. With tstconseg, a single collection of supervisory cells is sent in
the egress direction between the card and service equipment (CPE). (See tstdelay for ingress direction.)
When the test successfully starts, the system displays a message stating that the test has begun and
directs you to use either dspcon or dspchantests to see the results. The dspcon command shows detailed
information about the connection and has a field for the results of this test. The dspchantests command
display only the results of the test.
Note The dspcon fields on the AXSM for round trip delay—including the status of OAM loopback—always
show the results of the latest test and are not changed until a new execution of tstconseg or tstdelay.
Therefore, re-executing dspcon does not clear the value for RTD or the indication that an OAM loopback
is present. The only way to reset these fields to null is to down the port (through dnport).
Syntax
tstconseg <ifNum> <vpi> <vci> [-num <iterations>]
Syntax Description
Related Commands
dspcon, tstdelay, dspchantests
Attributes
Example
Test the integrity of 1 10 1000 in the egress direction.
M8850_LA.3.AXSM.a > tstcon 2 103 103 -num 2
tstconseg is in progress ..
Connection Id Test Type Direction Result Round Trip Delay
============= ========= ========= ======= ================
02.0103.00103: OAM Lpbk egress Success 2616 microsec
ifNum The logical port number. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
vpi The VPI range for the SVC or SPVC is 1–255.
vci The VCI range for the SVC is 1–65535.
-num (Optional) Specifies the number of times a collection of supervisory cells should traverse
the SVC for the current execution of tstconseg.
Log: yes State: active Privilege: GROUP1