Specifications

5-448
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
switchapsln
switchapsln
Switch APS Line—AXSM, AXSM-E, AXSM-XG
Switches the specified working APS line (bay, line) to its protection line.
See the description for the addapsln command for a detailed explanation of Automatic Protection
Switching (APS).
Syntax
switchapsln <bay> <line> <switchOption> [<serviceSwitch>]
Syntax Description
Related Commands
addapsln, cnfapsln, delapsln, dspapsln, dspapslns, dspapsbkplane, clrbecnt, dspbecnt
Attributes
Example
MGX8850.9.AXSM.a > switchapsln 1.1.1 3 1
Forced line switch from working to protection succeeded on line 1.1.1
bay The working bay number to switch.
line The working line number to switch.
switchOption The method of performing the switch.
1 = clear (returns to working line)
2 = lockout of protection
(locks out the specified APS pair from being switched to protection line)
3 = forced working->protection
(forces a working line to protection line switch unless the protection line is
locked out)
4 = forced protection->working
(forces a protection line to working line switch; 1+1 architecture mode only)
5 = manual working->protection (manual switch)
6 = manual protection->working (manual switch; 1+1 architecture mode only)
service switch When set to 1, this field causes all APS lines to switch.
Log: no State: active Privilege: GROUP1