Specifications

2-5
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 2 Preparing AXSM Lines for Communication
Quickstart Provisioning Procedures
Channelizing SDH Lines Configuration Quickstart
Note Channelizing is not supported on non-XG AXSM Cards. This section only applies to AXSM-XG cards
This procedure describes how to create channelized SDH lines on an AXSM-XG card:
i
Command Purpose
Step 1
username
<password>
Start a configuration session with the active PXM card.
Note To perform all the procedures in this quickstart
procedure, you must log in as a user with GROUP1
privileges or higher.
Step 2
cc <options> Change to an active AXSM-XG card on which you will configure
a path.
Step 3
upln Bring up a line. When you bring up a line, the corresponding SDH
path has a width of 3.
See the “Bringing Up Lines” section, which appears later in this
chapter.
Step 4
cnfln -<bay.line> -slt 2
-clk <clockSource>
Configure the line you brought up in Step 3 to be an SDH line.
See the “Channelizing an SDH Line” section on page 2-23.
Step 5
cnfpath -sts <pathid> -width
<width spec>
Related commands:
dsppath
dsppaths
From the active AXSM card, configure the SDH path width. See
the “Bringing Up and Configuring SDH Paths” section on
page 2-25.
Step 6
uppath -sts <pathid>
Related commands:
dsppath
dsppaths
Bring up the SDH path. See the “Bringing Up and Configuring
SDH Paths” section on page 2-25.
Step 7
cnfpath -sts <pathid> -payload
<sts_au_payload_type>
Related commands:
dsppath
dsppaths
Configure the payload type for the STS path you are
channelizing. See the “Bringing Up and Configuring SDH Paths”
section on page 2-25.
Step 8
uppath [-pathfilter] <pathid> Bring up the sub-paths that were created in Step 7.See the
“Bringing Up and Configuring SDH Paths” section on page 2-25.
Step 9
cnfpath <options>
Related commands:
dsppath
dsppaths
Configure the sub-paths. See the “Bringing Up and Configuring
SDH Paths” section on page 2-25..