Specifications

5-392

Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches

Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005

Chapter 5

dspsct

Display Service Class Template—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG

Use the dspsct command to display the contents of a port or card level service class template (SCT). For

more information on SCTs, see the description of SCTs in the switch software configuration guide.

With the dspsct command, you can display:

• Port or Card SCTs

• A particular SCT template

• A section within the SCT (see Syntax Description for an explanation)

Note Currently, the system does not support certain parameters in the service class templates (SCTs), so you

can specify them through addcon, cnfcon, or Cisco WAN Manager. These parameters are (when

applicable) PCR, SCR, and ICR.

Syntax

Syntax Description

Related Commands

cnfcdsct, dspcdsct, dspportsct, dspsct, setsctver

Attributes

gen

cosb

vcThr

cosThr

A specific part of the SCT, as follows:

• gen: general VC

• cosb: class of service buffer

• vcThr: VC thresholds

• cosThr: COSB thresholds

sctID SCT identifier in the range 1-255.

port | card Specifies the part of the card where the template applies. Enter

port or card.

Log: no State: active, standby Privilege: ANYUSER