Specifications

2-3
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 2 Preparing AXSM Lines for Communication
Quickstart Provisioning Procedures
Preparing Cards and Lines for Configuration Quickstart
The following quickstart procedure provides a summary of the tasks required to prepare AXSM lines for
configuration as ATM trunks and lines. This procedure is provided as an overview and as a quick
reference for those who already have configured Cisco MGX switches.
Command Purpose
Step 1
username
<password>
Start a configuration session with the active PXM card.
Note To perform all the procedures in this quickstart procedure,
you must log in as a user with GROUP1 privileges or
higher.
Step 2
addred <options> From the active PXM card, define which cards are operating as
redundant cards. See Table 2-1 for more details on redundancy
options supported.
For instructions on adding card redundancy, refer to the Cisco
MGX 8800/8900 Series Configuration Guide, Release 5.2.
Step 3
cc <options> Change to an active AXSM card from which you will select a card
SCT.
Step 4
cnfcdsct <sctid>
Related commands:
dspcd
Apply ATM communications parameters from a preconfigured
Service Class Template (SCT) file to all communications between
the card you are configuring and the other cards in the switch.
See the “Selecting and Viewing Service Class Templates”.
Step 5
upln <bay.line>
Related commands:
dsplns
dspln -type <bay.line>
Bring up lines. This step establishes physical layer connectivity
between two switches.
See the “Bringing Up Lines” section on page 2-10.
Step 6
cnfln <options>
Related commands:
dsplns
dspln -type <bay.line>
Configure lines. See the “Configuring Lines” section on
page 2-12.
Step 7
addapsln <workingIndex>
<protectIndex> <archmode>
Configure a redundant relationship between two AXSM lines.
See the “Establishing Redundancy between Two Lines with APS”
section on page 2-14.
Step 8
For an AXSM-XG only:
cnfpath
uppath
Related commands:
dsppath
dsppaths
Add and configure a channelized path. See the appropriate
following section, as applicable to the type of lines you are
configuring:.
• “Channelizing SONET Lines Configuration Quickstart”
section on page 2-4.
• “Channelizing SDH Lines Configuration Quickstart” section
on page 2-5.