Specifications

5-356
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dspports
dspports
Display Ports—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Displays general information about all logical ports on the card. On the AXSM, the information consists
of the following for each logical port:
• Logical port number (ifNum). On the AXSM, for example, the range is 1–60.
• Physical line number in the format bay.port.
• Operation status—whether the port is up or down.
• The minimum guaranteed rate in cells per second.
• The maximum allowed rate for the port in cells per second.
• The ID of the port-level SCT (see addport).
• The VPI number (applies only where virtual NNIs are available).
Note The operational state for standby cards is reported as N/A because the operational state of the standby
card may not be the same as the active card.
Syntax
dspports
Related Commands
addport, cnfport, delport, dspport
Attributes
Example
Display the logical ports on the AXSM.
MGX8850.1.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum SCT Id ifType VPI minVPI maxVPI
State State Rate Rate (D:dflt (VNNI, (EVNNI,EVUNI)
used) VUNI)
----- ---- ----- ----- ---------- --------- ------ ------ ------ ------ ------
1 2.1 Up Up 1412830 1412830 5 NNI 0 0 0
2 2.2 Up Up 1412830 1412830 5 NNI 0 0 0
3 1.1 Up Up 1412830 1412830 5 NNI 0 0 0
Log: no State: active, standby Privilege: ANYUSER