Specifications

5-342
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dsppart
dsppart
Display Resource Partition—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Displays information about one resource partition. The displayed information is shown in the example.
Note The dsppart and dsprscprtn commands are identical. The name “dsprscprtn” is consistent with the
corresponding command in Cisco MGX 8850 PXM1-based switch. You can use either command.
Note The connection count includes control VCs when you execute dsppart on the CLI of a service module.
However, when you execute dspcd or dsppnport(s) on the CLI of the controller card, the display does
not include control VCs.
The total number of connections in the display includes control VCs. The types of control VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see the connection counts that do not include
control VCs, use dsppnport.
Syntax
dsppart <ifNum> <partId>
Syntax Description
Related Commands
addpart, cnfpart, delpart, dspparts
Attributes
ifNum Logical interface (port) number. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
partId The partition identifier. If necessary, use the dspparts command to see existing
partition numbers. The range are as follows:
• AXSM: 1–5
• AXSM-E, AXSM-XG: 1–20
Log: no State: active, standby Privilege: ANYUSER