Specifications

5-301
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dspimalnks
dspimalnks
Display IMA Links—AXSM-32-T1E1-E
Displays the following configuration information for IMA links.
Syntax
dspimalnks
Syntax Description
No parameters
Related Commands
dspimalnk
Attributes
Example
MGX8850.2.AXSME.a> dspimalnks
Link Grp Rel Ne Ne NeRx Tx Rx
Num Num Dly Tx Rx Fail Lid Lid
(ms) State State Status
------------------------------------------------------------------------------
2.9 2.1 0 Usable Not In Grp Lif Fail 8 255
2.10 2.1 0 Usable Not In Grp Lif Fail 9 255
Information Description
imaLinkIfIndex This corresponds to the ifIndex of the MIB-II interface on which
this link is established. This object also corresponds to the logical
number (ifIndex) assigned to this IMA link.
imaLinkGroupIndex The value which identifies the IMA group (imaGroupIndex) of
which this link is a member.
imaLinkRelDelay The latest measured delay on this link relative to the link, in the
same IMA group, with the least delay.
imaLinkNeTxState The current state of the near-end transmit link
imaLinkNeRxState The current state of the near-end receive link.
imaLinkNeRxFailureStatus The current link failure status of the near-end receive link.
imaLinkTxLid The outgoing LID used currently on the link by the local end. This
value has meaning only if the link belongs to an IMA group.
imaLinkRxLid The incoming LID used currently on the link by the remote end as
reported via ICP cells. This value has meaning only if the link
belongs to an IMA group.
Log: no State: active Privilege: ANYUSER