Specifications

5-288
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dspimagrp
Syntax
dspimagrp <group>
Syntax Description
Related Commands
addimagrp, delimagrp, dspimagrpcnt, dspimagrps, cnfimagrp, rstrtimagrp, dspimalnk, addi-
malnk, delimalnk
Least delay link The ifIndex of the link configured in the IMA group that has the
smallest link propagation delay. A value of zero may appear if no
link has been configured in the IMA group or if the link with the
smallest link propagation delay has not yet been determined.
Tx timing reference link The ifIndex of the transmit timing reference link used by the
near-end for IMA data cell clock recovery from the ATM layer. A
value of zero may appear if no link has been configured in the group
or if the transmit timing reference link has not yet been selected.
Rx timing reference link The ifIndex of the receive timing reference link used by the near-end
for IMA data cell clock recovery toward the ATM layer. A value of
zero may appear if no link has been configured in the group or if the
receive timing reference link has not yet been selected.
Group running seconds The number of seconds the local IMA group has been running.
Alpha value This is the ’alpha’ value used to specify the number of consecutive
invalid ICP cells to be detected before moving to the IMA Hunt state
from the IMA Sync state.
Beta value This is the ’beta’ value used to specify the number of consecutive
errored ICP cells to be detected before moving to the IMA Hunt
state from the IMA Sync state.
Gamma value This is the ’gamma’ value used to specify the number of consecutive
valid ICP cells to be detected before moving to the IMA Sync state
from the IMA PreSync state.
TX OAM label IMA OAM Label value transmitted by the near-end IMA unit.
RX OAM label IMA OAM Label value transmitted by the far-end IMA unit. A 0
likely means that the IMA unit has not yet received an OAM label
from the far-end IMA unit.
Test pattern procedure status The current link test procedure status—enabled or disabled,
for example.
Test link The current link under test
Test pattern The current link test pattern
Information Description
group The bay number (1–2) and the IMA group number (1–16) in the format bay.group.
For example: 1.16