Specifications

5-224
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dspcd
dspcd
Display Card—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Use the dspcd command to display details about a card. On an AXSM or any other service module, you
can only display details for that service module. On a PXM, you can display information about the PXM
or another card. Different card types result in variations in the display. (See the Examples section.)
A list of information in the dspcd output follows:
• Serial numbers.
• Front and back card types and the status of each.
• Runtime and boot firmware revision numbers. (See the loadrev description for an explanation of
how to interpret the revision field.)
• Status, possibly including the reason for the last reset and state of the integrated alarm.
• When dspcd is entered on the CLI of a service module:
– A count of configured lines, ports, and connections
– Card-level SCT number
– The APS-related mode of an AXMS/A or AXSM/B
The dspcd display shows the physical lines that constitute a port group and the maximum number of
connections in that port group. A port group consists of one to many physical lines. This maximum
connection count is a function of the line type (OC-3, OC-12, and so on). The port group information
also shows the number of existing SVCs, SPVCs, and SPVPs. This part of the dspcd output can help you
configure resource partitions by showing the maximum number of supported connections. If a particular
resource partition has close to the maximum supported by hardware on a line, few or no connections
would be possible in another partition on the same line.
Note The total number of connections in the dspcd output includes control VCs. The types of control VCs are
SSCOP, PNNI-RCC, and ILMI (if ILMI is enabled). To see connection counts that do not include control
VCs, use dsppnport.
Syntax
dspcd
Syntax Description
No parameters
Related Commands
dspcds, dsppnport, dspversion
Attributes
Log: no State: active, standby Privilege: ANYUSER