Specifications

5-213
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dspatlaslndiagstat
dspatlaslndiagstat
Display Atlas Line Diagnostics Statistics—AXSM
Use the dspatlaslndiagstat command to display the current Atlas line diagnostics statistics for the
specified line.
Note The dspatlaslndiagstat command is an engineering command that is available only when the card is in
engineering mode. To enable engineering mode on the current card, enter the seteng on command.
Syntax
dspatlaslndiagstat <bay.line>
Syntax Description
Related Commands
cnfatlaslndiagstat, dspatlasdiagcnfcstat, dspaltlasdiagcstat, dspatlasdiagcnfstat
Attributes
Example
Display the Atlas line diagnostics statistics for line 1 on the current AXSM back card the top bay.
M8850_LA.1.AXSM.a > dspatlaslndiag 1.1
Device Count: idle Cell count:0
ing InputCell count: 93
ing OutputCell count: 93
egr InputCell count: 95
egr OutputCell count: 95
Phy Counts:Ingress: CLP0 cell count: 0
CLP1 cell count: 0
Valid OAM count: 0
Valid RM count: 0
Errored OAM and RM count: 0
invalid VPI/VCI/PTI count: 0
non zero GFC: 0
last unknown VCI: 0
last unknown VPI: 0
Phy Counts:Egress: CLP0 cell count:0
CLP1 cell count:0
Valid OAM count:0
Valid RM count:0
bay.line The line number for which to display the frame receive diagnostics statistics.
Note Enter the dsplns command to display valid numbers for all lines configured on
the current AXSM.
Log: no State: active/ standby Privilege: SERVICE_GP