Specifications

5-206
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
dspapsln
dspapsln
Display APS Line—AXSM, AXSM-E, AXSM-XG
Displays the configuration of an APS line. This command can be executed for either a working line or a
protection line.
See the addapsln command for an explanation of Automatic Protection Switching (APS).
Note Neither the dspapsln nor the dspapslns command shows the APS-related mode of an AXSM card. To
see the APS mode of an AXSM, run dspcd on the CLI of the AXSM. The field labeled “Card Operating
Mode” shows either AXSM-A or AXSM-B.
Syntax
dspapsln <working-slot.bay.line>
Syntax Description
Related Commands
addapsln, cnfapsln, delapsln, dspapslns, switchapsln, dspapsbkplane, clrbecnt, dspbecnt
Attributes
Example
Display the APS configuration for slot 1, bay 1, line 1.
Note The “Top Bay” or “Bottom Bay” field appears according to the bay you specify in the command. The
status of either “ENGAGED” or “DISENGAGED” indicates whether or not the minibackplane for the
specified shelf is properly seated. If the status is disengaged, you must reset the minibackplane.
MGX8850.1.AXSM.a > dspapsln 13.1.1
Working Section 1 : 13.1.1 Working Section 2 : 14.1.1
Provisioned Arch : 1+1AnxB Provisioned Direction : bi
Operational Arch : 1+1AnxB Operational Direction : bi
Active Line : Working Sec 1 WTR(min) : 5
Primary Section : Working Sec 1 Secondary Section : Working Sec 2
SFBer 10^-n : 3 SDBer 10^-n : 5
Revertive : No Last User Switch Req : No Request
Bridge State : Set Selector State : Working Sec 1
Protection Line Pending Request : SignalFailLowPriority
Working Line Pending Request : None
working-slot.bay.line Identity of the working line with the format slot.bay.line.
bay.line Identifies the slot number, the bay (1 or 2) and the line number. The line
number is from 1 to the highest numbered line on the back card.
Log: no State: active, standby Privilege: ANYUSER