Specifications

5-151
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
cnfport
cnfport
Configure Port—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Configures or changes the parameters of a logical port. You can use dspport to verify the changes.
If a resource partition is configured on the port, you must first down the port using dnport to change the
guaranteed rate (guaranteedRate), the maximum rate (maxrate), or the SCT ID (sctID) parameters using
the cnfport command. However, the guaranteed rate (guaranteedRate) and the maximum rate (maxrate)
must be set to the same value. After you change parameters, use the upport command to return the port
to operation.
Syntax
cnfport -if <ifNum> [-min <guaranteedRate>] [-max <maxrate>] [-sct <sctID>] [-minvpi <minVpi>]
[-maxvpi <maxvpi>]
Syntax Description
-if Logical interface (port) number. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
-min Specifies the guaranteed rate on a logical port in cells per second (cps). The cumulative
guaranteed rate cannot exceed the highest value in the following ranges:
OC3: 50–353207 cps
T3: 50–96000 (PLCP) or 104268 (ADM) cps
E3: 50–80000 cps
T1: 50–3622 cps
E1: 50–4528 cps
-minvpi Specifies the minimum VPI.
NNI range: 0 and 4095
UNI range: 0 and 255
EVNNI range: 0 and 4095
EVUNI range: 0 and 255
-maxvpi Specifies the maximum VPI.
NNI range: 0 and 4095
UNI range: 0 and 255
EVNNI range: 0 and 4095
EVUNI range: 0 and 255