Specifications

5-148
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5
cnfpath
Related Commands
dsppath, dsppaths, uppath, dnpath
Attributes
Example
Configure a ds3 path for ATM with a width of 1.
MGX8950.3.AXSMXG.a > cnfpath 1.1.1 -payload ds3 -width 1
Changing the path width.
MGX8950.1.AXSMXG.a > cnfpath 1.1.1 -width 12
Change in path width may be traffic affecting.
Do you want to proceed (Yes/No) ? y
MGX8950.1.AXSMXG.a >
MGX8950.1.AXSMXG.a > cnfpath 1.1.2 -width 1
Change in path width may be traffic affecting.
Do you want to proceed (Yes/No) ? n
command not executed
MGX8950.1.AXSMXG.a >
trace-string For STS paths, this option allows you to transmit and display trail trace
bytes. You can test the line by transmitting a group of numbers using cnfln
-txtrace and then displaying the result using the dshpln command to see if
the numbers are the same. Enter the keyword (-txtrace) followed by the
TraceString. Possible values are:
• On SDH, the trace-string is 15 bytes maximum.
• ON SONET lines, the trace-string is 62 bytes maximum.
AIScBitsCheck For DS3 paths, this option specifies whether to ignore or check the AIS
C-bit.
• 1–Chk C-bit
• 2–Ignore C-bit
plcp_spec For DS3 paths, enables or disable PLCP.
• 1–enable
• 2–disable
Log: yes State: active Privilege: GROUP1