Specifications

5-147

Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches

Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005

Chapter 5

cnfpath

Configure Path—AXSM-XG

Configures the attributes of the specified STS or DS3 path (path_num).

For an STS path, a service is provisioned by configuring the payload (-payload).

The path width (-width) may only be configured when the path is down.

Syntax

For STS:

cnfPath [pathType] <path_num> -width <width_spec> (path in down state only)

cnfPath [pathType] <path_num> [-payload <sts_au_payload_type>] [-txtrace <trace-string>]

Note -payload and -width options are applicable to channelized card only.

For DS3:

cnfpath [pathType] <path_num> [-cb <AIScBitsCheck>] [-plcp <plcp_spec>]

Syntax Description

path type Keyword that specifies the type of path you are configuring. Possible path

types are:

• -sts: sts/au path

• -ds3: ds3 path

path_num Identifies the path you want to configure.

Note If you do not know the path_num, enter the dsppaths command to

see a list of all path numbers on the current card.

width_spec Specifies the width of the path.

• 1 = sts1_stm0

• 3 = sts3c_stm1

• 12 = sts12c_stm4

• 48 = sts48c_stm16

• 192 = sts192c_stm64

sts_au_payload_type Specifies the payload type. Possible values are:

• atm

• ds3 (sts1_stm0 only)

Note If you select ds3, you must set the width to sts1_stm0. DS3

automatically carries ATM.