Specifications

5-131
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
cnfilmi
cnfilmi
Configure ILMI—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
Configures the card-level interim local management interface (ILMI) for the AXSM. Activating the
card-level ILMI through cnfilmi requires a pre-existing logical port (see addport) and resource partition
(see addrscprtn or addpart). No response appears unless an error occurs.
Note For network-level ILMI in relation to PNNI, run the PNNI-specific ILMI commands on the PXM45.
Syntax
cnfilmi -if <ifNum> -id <partitionID> [-ilmi <ilmiEnable>] [-vpi <vpi>] [-vci <vci>]
[-trap <ilmiTrapEnable>] [-s <keepAliveInt>] [-t <pollingIntervalT491>] [-k <pollInctFact(K)>]
Syntax Description
Related Commands
dspilmi, dspilmis, dspilmicnt, clrilmicnt, dnilmi, upilmi
Attributes
Example
MGX8850.1.AXSM.a > cnfilmi 1 1 -ilmi 1 -vpi 40 -vci 99 -s 10 -t 10 -k 10
-if Logical interface number. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
-id Partition ID in the range 1–20. (See description of addpart or addrscprtn for information
regarding resource partition ID.)
-ilmi Enable or disable ILMI. 1 = enable. 2 = disable.
-vpi VPI for the ILMI signaling connection. The range is 0–255. For AXSM-XG, the range is
1–4095 (for NNI ports).
-vci VPI for the ILMI signaling connection. The range is 0–65535.
-trap Enable or disable ILMI trap. 1 = enable. 2 = disable.
-s Keep alive interval. The range is 1–16 seconds.
-t Polling interval for T491 in the range 0–255 seconds.
-k Polling interval K in the range 0–255 seconds.
Log: yes State: active Privilege: GROUP1