Specifications

5-122
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
cnfcli
The following list shows the commands whose privilege you cannot change
Syntax
With a single iteration of the cnfcli command, you can either install the file with modified privilege
levels or direct the switch to revert to the default privilege levels. The possible sequences of this
command and its parameters are as follows:
cnfcli <accesslevel> <install> [full path file name]
cnfcli <accesslevel> <default>
Syntax Description
Related Commands
ftp, dspcli
Attributes
Example
Configure the system to revert to the default access levels.
MGX8850.11.AXSME.a > cnfcli accesslevel default
MGX8850.11.AXSME.a >
accesslevel The access level is a subcommand.
install Keyword that indicate Enter the keyword, install, followed by the full path
to the ASCII file, as shown in the following example:
install
full path file name The full path name of the ASCII file you want to install.
default Keyword that causes the system to revert to the default access levels. Do not
enter default with the install keyword or the <full path file name>.
Log: yes State: active, standby Privilege: GROUP1