Specifications

5-100
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
cnfapsln
cnfapsln
Configure APS Line—AXSM, AXSM-E, AXSM-XG
Configures the APS parameters for a line (working line). Use the cnfapsln command after creating the
line using the addapsln command.
See the description for the addapsln command for a detailed explanation of Automatic Protection
Switching (APS).
Syntax
cnfapsln -w <working line> -sf <SignalFaultBER> -sd <SignalDegradeBER> -wtr <Wait To Restore>
-dr <direction> -rv <revertive> -proto <protocol>
Note 1+1AnnexB operational mode is bi-directional, non-revertive, ITU protocol only.
Note On an AXSM, if the ArchMode configured by the addapsln command is 1+1–Annex B, only WTR
(-wtr), SF BER (-sf), and SD BER (-sd) are configurable with the cnfapsln command.
Syntax Description
-w Slot number, bay number, and line number of the active line to configure, in
the format:
slot.bay.line
Example: -w 1.1.1
-sf A number between 3 and 5 indicating the Signal Fault Bit Error Rate (BER),
in negative powers of ten:
• 3 = 10
-3
• 4 = 10
-4
• 5 = 10
-5
Example: -sf 3
-sd A negative power of 10 in the range 5–9 that indicates the Signal Degrade
Bit Error Rate (BER):
• 5 = 10
-5
• 6 = 10
-6
• 7 = 10
-7
• 8 = 10
-8
• 9 = 10
-9
Example: -sd 5