Specifications

5-54
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
clradjlnalmcnt
clradjlnalmcnt
Clear Adjacent Line Alarm Count—AXSM, AXSM-E, AXSM-32-T1E1-E, AXSM-XG
The clradjlnalmcnt command lets you clear the statistical alarms and alarm counters for the adjacent
back card in an automatic protection system (APS) configuration.
Note The clradjlnalmcnt command works for only inter-card APS.
Syntax
clradjlnalmcnt <bay.line>
Syntax Description
Related Commands
dspadjlnalm, dspadjlnalmcnt
Attributes
Example
On the card in slot 3, clear the alarm count for the card adjacent to bay 1, line 2.
Then, check the alarm count status for the same adjacent bay and line using time interval 1.
MGX8850.3.AXSME.a > clradjlnalmcnt 1.2
MGX8850.3.AXSME.a> dspadjlnalmcnt 1.2 1
Interval Number : 1
Section PM:
-----------
Num of LOSs : 0
Num of LOFs : 0
ESs : 1
SESs : 0
SEFSs : 0
CVs : 4
Line PM:
-----------
Num of AISs : 0
Num of RFIs : 0
Near End Far End
ESs : 1 0
SESs : 0 0
CVs : 39 0
UASs : 0 0
bay.line Identifies the bay (1 or 2) and the line number. The line number is 1 to the highest
numbered line on the back card.
Log: yes State: active Privilege: SUPER_GP