Specifications

5-48
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
bootchange
bootchange
Boot Change—AXSM
Sets the boot IP address and gateway address of the PXM45 card. The boot IP address is used only when
the PXM45 card boots up.
The only parameters you should enter are “inet on ethernet (e)” and “gateway inet (g).” The bootchange
command presents one parameter at a time. Therefore, press the Return (or Enter) key at each prompt
except for these two. The example in this description shows the two fields where you need to enter an IP
address and the fields you skip.
Note The boot IP address does not get saved with saveallcnf.
Note Use the ipifconfig command to assign IP addresses for the PXM45 and the shelf.
Syntax
bootchange
Related Commands
none
Attributes
Example
MGX8850.1.AXSM.a > bootChange
'.' = clear field; '-' = go to previous field; ^D = quit
boot device : lnPci
processor number : 0
host name :
file name :
inet on ethernet (e) : 172.29.52.6
inet on backplane (b):
host inet (h) : 0.0.0.0
gateway inet (g) : 172.29.52.1
user (u) :
ftp password (pw) (blank = use rsh):
flags (f) : 0x0
target name (tn) : ??????????
startup script (s) :
other (o)
Log: yes State: active Privilege: SERVICE_GP