Specifications

5-41
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
addport
• For AXSM-32-T1-E1-E, use SCT 52 (policing) or SCT 53 (non-policing). The maximum VC/CoSB
cell threshold setting is the same for both SCT 52 or SCT 53.
The high-level distinctions between SCTs 2, 3, 4, and 5 are as follows:
• SCT 2 contains policing parameters, but SCT 3 does not.
• SCT 4 contains policing parameters, but SCT 5 does not.
• If your network design includes eventual configuration of partitions for MPLS, you may need SCT
4 or 5 (or derivations of 4 or 5 that you create through Cisco WAN Manager).
Cisco Systems provides SCTs 2 and 3 with Release 2.0. Additionally, it provides SCTs 4 and 5 with
Release 2.1 Cisco Systems encourages users who have upgraded from 2.0 to 2.1 to use SCT 4 or 5 for
new card and port configurations. For example, if MPLS is implemented, SCT 4 or 5 may be required.
The following two types of tasks may be helpful before you assign SCTs:
• To see the actual values in an SCT, use dspportsct for a port SCT or dspcdsct for a card-level SCT.
• To see a list of SCT files on the disk, use cd to reach the SCT directory, then execute ls to display
the contents of the AXSM directory. See the Example section for an illustration of this task.
You should use the provided SCTs or create new templates by using the Cisco WAN Manager application
to modify the provided SCTs and saving them with new SCT numbers.
Until you specify an SCT, the AXSM has a default SCT of 0. The system uses SCT ID = 0 when:
• The AXSM is powered-up for the first time.
• The card’s database is rebuilt.
• The card is rebooted and the user-specified SCT file for a particular port is corrupt or missing. In
this situation, the default applies to only the affected port.
Syntax (AXSM, AXSM-E, AXSM-32-E)
addport <ifNum> <bay.line> <guaranteedRate> <maxRate> <sctID> <ifType> [-vpi vpi]
[-minvpi minvpi] [-maxvpi maxvpi]
Syntax (AXSM-XG)
addport <ifNum> <path_num> <guaranteedRate> <maxRate> <sctID> <ifType> [-vpi vpi]
[-minvpi minvpi] [-maxvpi maxvpi]
Note For all ports on all AXSM cards, guaranteedRate must be the same as maxrate.