Specifications

5-37
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
addpart
AXSM-E, AXSM-XG Dependencies
A dependency exists between the addcontroller command on the PXM45 and the addpart
(addrscprtn) command on the AXSM-E and AXSM-XG. Both commands take a controller ID (ctrlr_id)
as an input. Both of these controller IDs must be the same when referring to the same VSI controller.
The sequence for executing these two commands should be as follows:
1. Run addcontroller on the PXM45 to specify the location of the VSI controller.
2. Run addpart (addrscprtn) on the AXSM-E or AXSM-XG to add resource partitions for the VSI
controller.
To support legacy service modules and earlier implementations of VSI, only the following combinations
of controller ID (ctrlr_id) values 1, 2, and 3 and controller type (cntrlrType) values are supported:
controller ID value 1 and controller type value 1 (PAR)
controller ID value 2 and controller type value 2 (PNNI)
controller ID value 3 and controller type value 3 (MPLS)
For all other controller ID values, any combination of controller type is supported.
Note cntrlrType is an addcontroller parameter.
Syntax
addpart <if_num> <part_id> <ctrlr_id> <egrminbw> <egrmaxbw> <ingminbw> <ingmaxbw>
<min_vpi> <max_vpi> <min_vci> <max_vci> <minConns> <maxConns>
Syntax Description
if_num Logical interface (port) number. The ranges are:
AXSM: 1–60
AXSM-E: 1–32
AXSM-XG: 1–126
part_id The partition ID number. The ranges are as follows:
AXSM: 1–5
AXSM-E: 1–20
ctrlr_id A number that identifies a network controller. The range for reserved controller IDs is
1–3 and is the same for all AXSM models. The reserved controller IDs are as follows:
1 = PAR (Portable AutoRoute)—currently not used
2 = PNNI
3 = LSC (Label Switch Controller, also known as MPLS for Multiprotocol Label Switch
Controller)
The absolute ranges for the AXSM and AXSM-E are as follows:
AXSM: 1–60
AXSM-E: 1–32