Specifications

5-24
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
addfdr
addfdr
Add Feeder—AXSM, AXSM-E, AXSM-XG
Adds a feeder node connection to the specified port (ifNum). The interface numbers of active ports are
displayed in the dspports command report. LMI is up by default when you use addfdr.
Note This command is unsupported on a Cisco MGX 8950 switch.
When adding a feeder node, the following conditions apply:
• You can add a feeder node only to an already existing port (ifNum).
• You cannot add a feeder node to a port that already has a connection established on it.
• You cannot add a feeder node to a port with ILMI enabled.
• You cannot enable ILMI on a port that has a feeder node connection on it.
For more detailed information on configuring a feeder, refer to the Cisco MGX 8800/8900 Series
Configuration Guide, Release 5.2.
Syntax
addfdr <ifNum>
Syntax Description
Related Commands
delfdr, dspfdr, dspfdrs
Attributes
Example
MGX8850.1.AXSM.a > addfdr 1
ifNum The interface number of the port to which the feeder node connection will be added.
The interface numbers of active ports are displayed in the dspports command report.
The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
Log: yes State: active Privilege: GROUP1