Specifications

5-22
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
addcon
• The type of card does not support a certain feature.
• The port cannot support SPVCs.
One of the following error messages appears if one of the preceding causes is true:
• “Port does not support requested service Type”
• “lscr/lmcr not allowed to exceed lpcr (dcmp)”
• “rscr not allowed to exceed rpcr”
• “lpcr must be defined for cbr service Type”
• “rpcr must be defined for cbr serviceType”
• “lpcr and lscr must be defined for vbr service Type”
• “rpcr and rscr must be defined for vbr service Type”
• “lpcr must be defined for abr/ubr service Type”
• “rpcr must be defined for abr/ubr service Type”
• “Requested rcdv is too low”
• “Requested rctd is too low”
• “Requested max cell loss ratio (clr) is too high”
• “Requested cell rate (lscr/lpcr) is too high”
• “Requested cell rate (rscr/rpcr) is too high”
Related Commands
cnfcon, cnfabr, delcon, dspcon, dspcons, dncon, upcon
Attributes
Example
Add the slave end of a VCC on logical port 1 with VPI = 10, VCI = 40, CBR service type. Note that the
system returns the slave end connection identifier in the hexadecimal NSAP format with the VPI.VCI at
the end. When you add the master endpoint of the connection, type –slave followed by this connection
identifier. You can do a copy and paste rather than typing the whole string.
MGX8850.AXSM.a >addcon 1 10 40 1 s
slave endpoint added successfully
slave endpoint id: 00000E1000001C008051B730FFFFFF010B180100.10.40
In the following two examples, the connection works with default values of PCR, SCT, MCR taken from
the SCT. Defaults applied for the connection can be viewed by using the dspcon command.
MGX8850.1.11.AXSME.a > addcon 1 10 40 1 s
slave endpoint added successfully
slave endpoint id : 00000E1000001C008051B730FFFFFF010B180100.10.40
MGX8850.1.11.AXSME.a > addcon 1 10 50 1 m -slave
00000E1000001C008051B730FFFFFF010B180100.10.40
master endpoint added successfully
master endpoint id : 00000E1000001C008051B730FFFFFF010B180100.10.50
Log: yes State: active Privilege: GROUP1