Specifications

5-16
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
addcon
ifNum The logical interface (or port) number. This ifNum corresponds to the ifNum added
through the addport command. The ranges are:
• AXSM: 1–60
• AXSM-E: 1–32
• AXSM-XG: 1–126
When you add an endpoint on an NNI, make sure that PNNI signaling is disabled on
the PXM45 (cnfpnportsig <portid> -nniver none).
vpi Virtual path identifier. Possible values are:
• UNI: 0–255
• NNI or VNNI: 0–4095; For VNNI, also specify one VPI per port.
vci Virtual connection identifier (VCI) for a VCC. Possible values are:
• If UNI, VCI can be 1–4095
• If NNI or VNN, VCI can be 1–65535
• If MPLS, recommended minimum VCI is 35
Virtual connection identifier (VCI) for a VPC. Possible values are:
• VCI = 0
Note VPC with VPI=0 provisioning is supported only on AXSM/E card.
service type Value in the range 1–12 to specify the service type:
• 1 = CBR1 (Constant Bit Rate 1)
• 2 = VBR1RT (Variable Bit Rate 1, Real Time)
• 3 = VBR2RT (Variable Bit Rate 2, Real Time)
• 4 = VBR3RT (Variable Bit Rate 3, Real Time)
• 5 = VBR1NRT (Variable Bit Rate 1, Non-Real Time)
• 6 = VBR2NRT (Variable Bit Rate 2, Non-Real Time)
• 7 = VBR3NRT (Variable Bit Rate 3, Non-Real Time)
• 8 = UBR1 (Unspecified Bit Rate 1)
• 9 = UBR2 (Unspecified Bit Rate 2)
• 10 = ABRSTD (Standard ABR—see cnfabr for VS/VD-specific parameters)
• 11 = CBR2 (Constant Bit Rate 2)
• 12 = CBR3 (Constant Bit Rate 3)
Note CBR2 and CBR3 will be obsoleted in the future. Use CBR1 instead.
Note The cnfabr command is not available on AXSM/A and AXSM/B cards.
mastership Value to specify the endpoint as master or slave. Possible values are:
• 1 = master end
• 2 = slave end