Specifications

5-15
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 5 AXSM Command Reference
addcon
• The following devices can terminate the far endpoint (the “party”):
– AXSM-XG
– AXSM-E
– SES/BPX
– PXM1E network interface
OAM and Failure Management
OAM functionality is not supported for P2MP connections (OAM needs two way communication of
OAM cells). Further, the following functionality is not supported on P2MP connections:
• Continuity check (CC, configured through the addcon command for P2MP connections)
• tstdelay operation
• AIS propagation in case of UNI port failure
At the P2MP root, the following functionality is supported:
• tstconseg operation
• Segment OAM endpoint
• AIS upon connection failure, such as a failure to route or connection down by dncon usage
Syntax (AXSM)
addcon ifNum vpi vci serviceType mastership
[-casttype <value>]
[-slave <value>]
[-lpcr <local -> remote PCR>] [-rpcr <remote -> local PCR>]
[-lscr <local -> remote SCR>] [-rscr <remote -> local SCR>]
[-lmbs <local -> remote MBS>] [-rmbs <remote -> local MBS>]
[-lcdv <local -> remote maxCDV>] [-rcdv <remote -> local maxCDV>]
[-lctd <local -> remote maxCTD>] [-rctd <remote -> local maxCTD>]
[-lmcr <local -> remote MCR>] [-rmcr <remote -> local MCR>]
[-cdvt <local CDVT>] [-cc <OAM CC Cnfg>] [-stat <Stats Cnfg>]
[-frame <frame discard>] [-mc <Max Cost>]
[-lputil <local -> remote PUtil>]
[-rputil <remote -> local PUtil>]
[-slavepersflag <slavepers>]
[-rtngprio <routingPriority>]
[-prefrte <preferredRouteId>]
[-intvsvd <internal vsvd config>]
[-extvsvd <external vsvd config>]
[-directrte <directRoute>]
Note To specify an OAM segment endpoint, use the cnfcon command after you have created the connection
by using the addcon command. The cnfcon parameter is -segep.
Syntax Description
For the applicable parameters, the “local” end is the point at which you are provisioning the connection.