Specifications

4-49
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 4 AXSM Card Management
Managing Connections
Endpoint Reference: 11
To display information about the specific party you want to modify, enter the dspparty command as
follows:
MGX8850.8.PXM.a > dspparty < portid > < vpi > < vci < -epref < epref >
Table 4-13 describes the dspparty command parameters.
Step 3 Enter the dnparty command to bring down the party you want to reroute.
MGX8850.8.PXM.a > dnparty < port > < vpi > < vci > < epref >
Table 4-13 describes the dnparty command parameters.
Step 4 Enter the rrtparty command to reroute the appropriate party.
MGX8850.8.PXM.a > rrtparty < port > < vpi > < vci > < epref >
Table 4-13 describes the rrtparty command parameters.
Step 5 Enter the upparty command to bring the rerouted party back up.
MGX8850.8.PXM.a > upparty < port > < vpi > < vci > < epref >
Table 4-13 describes the upparty command parameters.
Step 6 Enter the dspparty command as shown in the following example to verify that the party was rerouted
correctly.
MGX8850.8.PXM.a > dspparty < portid > < vpi > < vci < -epref < epref >
Deleting a P2MP Party Configuration
Before you can delete a P2MP connection, you must first delete all parties associated with that
connection. A P2MP connection will remain as long as there are parties configured. For example, a
P2MP connection that has 100 parties will remain in service, even if 99 of those parties are down.
To delete a party from a P2MP connection, enter the delparty command, as shown in the following
example:
MGX8850.8.PXM.a > delparty <port> <vpi> <vci> <epref>
The delparty command parameters are the same parameters you set with the addparty command.
One you have deleted all parties on a P2MP connection, you can delete the connection itself by entering
the delcon command as follows:
Table 4-13 addparty Command Parameters
Parameter Description
port Port identifier, in the format [shelf.]slot[:subslot].port[:subport]
vpi vpi range (UNI: 0..255 | NNI: 0..4095)
vci vci range 35..65535
epref endpoint reference range 1..32767