Specifications

4-46
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 4 AXSM Card Management
Managing Connections
--------------------------------------------------------------------------
Type <CR> to continue, Q<CR> to stop:
OAM CC Config : DISABLED Statistics : DISABLED
--------------------------------------------------------------------------
Loopback Type : No Lpbk | Dir: N/A | Status: No Lpbk | RTD: 0us
--------------------------------------------------------------------------
--------------------------------------------------------------------------
Port side Tx : normal Swth side Tx : normal
Port side Rx : normal Swth side Rx : normal
--------------------------------------------------------------------------
I-AIS/RDI E-AIS/RDI CONDITIONED CCFAIL IfFail Mismatch LMI-ABIT
NO NO NO NO NO NO NO
--------------------------------------------------------------------------
M8850_LA.3.AXSM.a >
Deleting ATM Connections
Use the following procedure to delete an ATM connection.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 Enter the delcon command as follows to delete an ATM connection:
delcon < ifNum > < vpi > < vci >
Replace <ifNum> with the number of the interface whose connection you want to delete. Replace
<vpi> with the VCI of the connection you want to delete. Replace <VCI> with the VCI of the
connection you want to delete.
Note Enter the dspcons command to obtain the interface number, VPI, and VCI of a connection.
In the following example, the user deletes the connection on port 2 with a VPI of 101 and a VCI of 101.
M8850_LA.3.AXSM.a > delcon 2 101 101
Deletion successful
M8850_LA.3.AXSM.a >
Removing a Cisco IGX Feeder Connection
This procedure describes how to remove an IGX feeder connection from an MGX 8850 AXSM card.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 Enter the delcon or delcons command to delete all ATM connections to the IGX feeder.
Note Enter the dspcons command to obtain the interface number, VPI, and VCI of a connection.