Specifications

4-45
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 4 AXSM Card Management
Managing Connections
Note The Identifier column identifies the interface number, VPI, and VCI for each connection on the
current card. You will need these values for any connection you want to display, configure, or
delete.
Displaying the Status of a Single ATM Connection
Use the following procedure to display the configuration and status of a single ATM connection:
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 Enter the dspcons command as shown in the following example to display a list of all active connections
on the current AXSM.
M8850_LA.3.AXSM.a > dspcons
record Identifier Type SrvcType M/S Upld Admn Alarm
------ ---------- ---- -------- --- ---- ---- -----
0 01 0101 00101 VCC cbr1 S 00000006 UP none
1 02 0103 00103 VCC cbr1 M 00000007 UP none
2 03 0105 00105 VCC cbr1 M 00000003 UP multiple
M8850_LA.3.AXSM.a >
Step 3 Enter the dspcon command as follows to display the configuration and connection status of a single
connection on the current AXSM.
dspcon < ifNum > < vpi > < vci >
Replace <ifNum> with the number of the interface whose connection you want to display. Replace <vpi>
with the VCI of the connection you want to display. Replace <VCI> with the VCI of the connection you
want to display.
In the following example, the user displays the connection on port 2, with a VPI of 103 and a VCI of 103.
M8850_LA.3.AXSM.a > dspcon 2 103 103
--------------------------------------------------------------------------
Local : NSAP Address vpi vci
(M) 4700918100000000036B5E2BB200000103180200 103 103
Remote : NSAP Address vpi vci
(S) 4700918100000000036B5E2BB200000103180100 101 101
--------------------------------------------------------------------------
Conn. Type : VCC Admn Status : ADMN-UP
Service Type : cbr1 Oper Status : OK
Controller : 2 Record # : 1
SlavePersist : YES Cast-type : P2P
--------------------------------------------------------------------------
Local PCR : 50 Remote PCR : 50
Local SCR : N/A Remote SCR : N/A
Local CDV : -1 Remote CDV : -1
Local CTD : -1 Remote CTD : -1
Local MBS : N/A Remote MBS : N/A
Max Cost : -1 Frame discard: DISABLED
Local CDVT : 250000 OAM segment : ENABLED
Local PctUtil : 100 Rmt PctUtil : 100
Priority : 8
Pref Rte Id : 0 Directed route: NO