Specifications

4-42
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 4 AXSM Card Management
Managing Resource Partitions
-imin
<ingMinBw>
Specifies the guaranteed percentage of the ingress bandwidth. Each unit of
ingMinBw is 0.0001 of the total bandwidth available to the port. For example,
an ingMinBw of 1000000 = 100%.
Enter the -imin keyword followed by the minimum percentage of ingress
bandwidth, for example:
-imin 10000
-imax
<ingMaxBw>
Specifies the maximum percentage of the ingress bandwidth. Each increment of
ingMaxBw is 0.0001 of the total bandwidth on the port. For example, an
ingMaxBw of 1000000 = 100%. Note that the maximum ingress bandwidth must
be at least 50 cps.
Enter the -imax keyword followed by the maximum percentage of the ingress
bandwidth, for example:
-imax 100000
-vpmin
<minVpi>
Specifies the minimum VPI. For NNI, the range is 0–4095. For UNI, the range
is 0–255.
Enter the -vpmin keyword followed by the minimum VPI, for example:
-vpmin 100
-vpmax
<maxVpi>
Specifies the maximum VPI in the range 0–4095 for an NNI. For a UNI, the
range is 0–255. The maxvpi cannot be less than the minvpi.
Enter the -vpmax keyword followed by the maximum VPI, for example:
-vpmax 200
-vcmin
<minVci>
Minimum VCI range. Enter a number in the range from 1 through 65535.
Enter the -vcmin keyword followed by the minimum VCI, for example:
-vcmin 100
-vcmax
<maxVci>
Maximum VCI range. Enter a number in the range from 1 through 65535. The
vcmax cannot be less than the vcmin.
Enter the -vcmax keyword followed by the maximum VCI, for example:
-vcmax 60000
-mincon
<min connections>
Specifies the guaranteed number of connections. The range is between 0 and the
maximum number of connections in the port group.
Enter the -mincon keyword followed by the interface (or port) number, for
example:
-mincon 0
Note Enter the dspcd command for information about port groups.
-maxcon
<max connections>
Specifies the maximum number of connections. The range is between 10 and the
maximum number of connections in the port group.
Enter the -maxcon keyword followed by the interface (or port) number, for
example:
-maxcon 120000
Note Enter the dspcd command for information about port groups.
Table 4-12 Keywords and Arguments for the cnfpart Command (continued)
Argument Description