Specifications

4-11

Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches

Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005

Chapter 4 AXSM Card Management

Managing Port SCTs

Note Enter the dspports command to see a list of all port numbers on the current card.

Cisco provides SCT numbers 2, 3, 4, and 5. You can modify one of these SCTs through the Cisco WAN

Manager application and assign a number in the range 6–255 to the new SCT. Subsequently, you can

assign the new SCT to the port with the sctID parameter in cnfport. To see the ID of the current SCT for

this port, use dspport. To see the parameters within the current SCT, use the dspportsct command.

Note An SCT must be registered before you can select it for a card or port. The exception to this requirement

is the default SCT (SCT 0), which is permanently registered. For instructions on registering SCTs, see

the Cisco MGX 8800/8900 Series Configuration Guide, Release 5.2.

Displaying Port SCT Settings

To view the port SCT settings, use the following procedure.

Step 1 Establish a CLI management session at any user access level.

Step 2 Enter the dspportsct command to display the port SCT settings on the current card. Note that the

command parameters for the dspportsct command vary according to type of AXSM card you are

working on.

To display the port SCT settings on an AXSM/A, AXSM/B, or AXSM-XG card, enter the dspportsct

command as follows:

M8850_SF.5.AXSM.a > dspportsct <bw|gen|cosb|vcThr|cosThr> <ifNum>

To display the port SCT settings on an AXSM-E card, enter the dspportsct command as follows:

Select one of the options to display one of the five SCT configuration reports, and replace <ifNum> with

the number of the port you want to view. Table 4-3 describes the reports for each of these options.

Note The option names are case sensitive. The switch does not recognize the vcthr option. You must

enter vcThr.

Table 4-3 Options for dspportsct Command

Option Description

abr Displays ABR pramaters (i.e., abr, gen, cosb, vcThr, cosThr)

gen Displays general SCT parameters.

cosb Displays COSB parameters.

vcThr Displays virtual circuit threshold parameters.

cosThr Displays COSB threshold parameters.

if Displays interface between 1 and 126.