Specifications

4-6
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 4 AXSM Card Management
Managing Card SCTs
Use this command only to modify partition parameters or change SCT
Do you want to proceed (Yes/No) ? y
Step 5 Configure the SCT using the cnfcdsct command.
cnfcdsct < sctID >
Replace sctID with the number of the SCT that you want to assign to the card. Table 4-2 describes the
SCTID options.
Step 6 To verify the SCT change, enter the dspcd command. The displayed report displays a row labeled “Card
SCT Id,” which identifies the SCT assigned to the card.
Step 7 Enter the upallports command to bring up all ports. If you want to bring up ports individually, enter the
upport command.
M8850_LA.2.AXSM.a > upallports
Step 8 Enter the dspports command to verify that the appropriate ports are up.
M8850_LA.1.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum SCT Id ifType VPI minVPI maxVPI
State State Rate Rate (D:dflt (VNNI, (EVNNI,EVUNI)
used) VUNI)
----- ---- ----- ----- ---------- --------- ------ ------ ------ ------ ------
1 2.1 Up Up 1412830 1412830 5 NNI 0 0 0
2 2.2 Up Up 1412830 1412830 5 NNI 0 0 0
3 1.1 Up Up 1412830 1412830 5 NNI 0 0 0
Displaying Card SCT Settings
To view the card SCT settings, use the following procedure:
Step 1 Establish a CLI management session at any user access level.
Step 2 Enter the dspcdsct command to display the card SCT settings on the current card. Note that the
command parameters for the dspcdsct command vary according to type of AXSM card you are working
on.
To display the card SCT settings on an AXSM/A, AXSM/B, or AXSM-XG card, enter the dspcdsct
command using the following syntax:
dspcdsct <gen|cosb|vcThr|cosThr>
To display the card SCT settings on an AXSM-E card, enter the dspcdsct command, using the following
syntax:
dspcdsct <abr|gen|cosb|vcThr|cosThr|qeCosb|qeVcThr>
Select one of the options to display one of the five SCT configuration reports. Table 4-2 describes the
reports for each of these options. The following section lists sample reports for each of these options.
Note The option names are case sensitive. For example, the switch does not recognize the vcthr
option. You must enter vcThr.