Specifications

4-5
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 4 AXSM Card Management
Managing Card SCTs
PCA Part#: 73-5045-4 73-5087-2 73-5087-2
CLEI Code: BAA62CWCAA 0 00
Reset Reason: Power ON Reset
Card Operating Mode: AXSM-B
SCT File Configured Version: 1
SCT File Operational Version: 1
Card SCT Id: 5
Type <CR> to continue, Q<CR> to stop:
Selecting or Changing a Card SCT
A card SC T defines the queue param eters for the destination slot based cell queues tow ards the backplane.
The same card SCT may be used for multiple cards of the same card type. When an AXSM card is
powered up for the first time, the default card SCT file is used. The default card SCT is 0.
Note An SCT must be registered before you can select it for a card or port. The exception to this requirement
is the default SCT (SCT 0), which is permanently registered. For instructions on registering SCTs, see
the Cisco MGX 8800/8900 Series Configuration Guide, Release 5.2.
To select an SCT for a card, use the following procedure.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 Enter the cc command to change to the active service module for which you will select or change an SCT.
M8850_LA.8.PXM.a > cc 2
(session redirected)
M8850_LA.2.AXSM.a >
Note In a redundant pair, you must specify the SCT on the active card.
Step 3 All ports on the card must be down before you can change the card SCT. To verify the status of the ports
on the card, enter the dspports command.
M8850_LA.2.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum SCT Id ifType VPI minVPI maxVPI
State State Rate Rate (D:dflt (VNNI, (EVNNI,EVUNI)
used) VUNI)
----- ---- ----- ----- ---------- --------- ------ ------ ------ ------ ------
1 2.1 Up Down 1412830 1412830 5 NNI 0 0 0
2 2.2 Up Down 1412830 1412830 5 NNI 0 0 0
3 1.1 Up Up 1412830 1412830 5 NNI 0 0 0
Step 4 Enter the dnallports command to bring down all ports that are in the Admin State “Up”.
M8850_LA.2.AXSM.a > dnallports
dnport/dnallports can disrupt traffic on existing connections.