Specifications

3-57
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
General AXSM Configuration Procedures
If you omit an optional parameter, the SPVC/SPVP uses the default value.
Tip The PCR, MBS, CDVT, CDV, MCR, and CTD configuration options are optional. If you omit one of
these options when entering the addcon command, the connection uses the default value. To override the
default values for any option, enter the option with a new value.
The following command example defines a port as the master side of an SPVC. Note the master ID
shown in the command response.
M8950_DC.5.AXSM.a > addcon 3 101 101 1 1 -slave
4700918100000000001A531C2A00000101180300.101.101
master endpoint added successfully
master endpoint id : 4700918100000000107B65F33C0000010A180300.101.101
Step 4 Verify the master-side SPVC addition by entering the following command:
M8950_DC.5.AXSM.a > dspcons
The switch displays a report showing all connections. The following example shows a report for a switch
with one connection:
M8950_DC.5.AXSM.a > dspcons
record Identifier Type SrvcType M/S Upld Admn Alarm
------ ---------- ---- -------- --- ---- ---- -----
0 03 0101 00101 VCC cbr1 M 02022c36 UP none
Step 5 To display the configuration for a single connection, enter the following command:
MGX8850.9.AXSM.a > dspcon ifNum vpi vci
Replace the ifNum parameter with the interface or port number. The following example shows a dspcon
command report.
M8950_DC.5.AXSM.a > dspcon 3 101 101
--------------------------------------------------------------------------
Local : NSAP Address vpi vci
(M) 4700918100000000107B65F33C0000010A180300 101 101
Remote : NSAP Address vpi vci
(S) 4700918100000000001A531C2A00000101180300 101 101
--------------------------------------------------------------------------
Conn. Type : VCC Admn Status : ADMN-UP
Service Type : cbr1 Oper Status : OK
Controller : 2 Record # : 0
--------------------------------------------------------------------------
Local PCR : 50 Remote PCR : 50
Local SCR : N/A Remote SCR : N/A
Local CDV : -1 Remote CDV : -1
Local CTD : -1 Remote CTD : -1
Local MBS : N/A Remote MBS : N/A
Max Cost : -1 Frame discard: N
Local CDVT : 250000
--------------------------------------------------------------------------
OAM CC Config : DISABLED Statistics : DISABLED
--------------------------------------------------------------------------
Loopback Type : No Lpbk | Dir: N/A | Status: No Lpbk | RTD: 0us
--------------------------------------------------------------------------
Type <CR> to continue, Q<CR> to stop:
--------------------------------------------------------------------------
Port side Tx : normal Swth side Tx : normal
Port side Rx : normal Swth side Rx : normal