Specifications

3-53
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
General AXSM Configuration Procedures
To start or restart ILMI with the upilmi command, use the following procedure.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 If you have not already done so, configure PNNI signaling as described in the “Selecting the Port
Signaling Protocol” section on page 3-44.
Step 3 Enter the cc command to select the AXSM card on which you want to start ILMI.
Step 4 If you do not know the interface number and partition ID for the port on which you are starting ILMI,
enter the dspparts command as shown in the following example.
M8950_DC.5.AXSM.a > dspparts
if part Ctlr egr egr ingr ingr min max min max min max
Num ID ID GuarBw MaxBw GuarBw MaxBw vpi vpi vci vci conn conn
(.0001%)(.0001%)(.0001%)(.0001%)
-----------------------------------------------------------------------------
11 1 2 500000 500000 500000 500000 11 4095 35 65535 100 4000
11 2 5 500000 500000 500000 500000 0 10 32 65535 1000 4000
Tip To see the relationship between interface numbers and lines, enter the dspports command.
Step 5 To start ILMI on a port, enter the upilmi command as follows:
M8950_DC.5.AXSM.a > upilmi < ifNum > < partId >
Replace ifNum with the interface number for the port, and replace partId with the partition number
assigned to the port. For example:
M8950_DC.5.AXSM.a > upilmi 2 1
Step 6 To display the ILMI status of all the ports on an AXSM card, enter the dspilmis command. For example:
M8950_DC.5.AXSM.a > dspilmis
Sig. rsrc Ilmi Sig Sig Ilmi S:Keepalive T:conPoll K:conPoll
Port Part State Vpi Vci Trap Interval Interval InactiveFactor
---- ---- ---- ---- ---- --- ------------ ---------- ----------
11 1 On 11 16 On 1 5 4
11 2 Off 0 16 On 1 5 4
The ILMI State column displays the configured state for ILMI, which is On if ILMI is enabled and Off
if ILMI is disabled (use dsppnports or dsppnilmi to see the operational state).
Configuring AXSM Line Clock Sources
To configure the switch to receive a clock source on an AXSM line, you must do the following tasks:
• Connect a line between the AXSM and the node with the clock source
• Activate the line
• Create a logical port (subport) for the clock signal
• Create a resource partition