Specifications

3-47
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
General AXSM Configuration Procedures
When assigning the static address, you can use command options to define how widely the static address
is advertised within the switch network. Use the following procedure to define a static address for a UNI
port.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 To locate the port to which you want to add an address, enter the dsppnports command.
Step 3 Enter the cnfaddrreg command to turn off automatic address registration (it is enabled by default) on
the port that will use the static address:
MGX8850.7.PXM.a > cnfaddrreg < portid > no
Replace portid using the format slot:bay.line:ifNum.
Step 4 Specify an ATM address for the port using the addaddr command:
addaddr [ shelf.]slot[:subslot].port[:subport ] atm-address length [-type {int|ext}]
[-proto {local | static}] [-plan {e164|nsap}] [-scope value] [-redst {yes|no}]
[-tnid tnid]
Note The addaddr command is used to specify static addresses for UNI links to CPE and to define
destination addresses for AINI and IISP static links. The command format above shows the
options that apply when defining static addresses for CPE.
Replace <portid> with the ID you used with the cnfaddreg command described earlier.
The following example assigns an ATM address to port 9:1.2:2:
MGX8850.7.PXM.a > addaddr 1:2.1:3 47.1111.1111.1111.1111.1111.1111.1111.1111.1111.11 160
Step 5 To verify that the new address has been assigned, enter the dspatmaddr command as shown in the
following example:
MGX8850.7.PXM.a > dspatmaddr 2:2.2:1
Port Id: 2:2.2:1
Configured Port Address(es) :
47.1111.1111.1111.1111.1111.1111.1111.1111.1111.11
length: 160 type: internal proto: local
scope: 0 plan: nsap_icd redistribute: false
Configuring ILMI on a Port
Interim Local Management Interface (ILMI) is a feature you can activate on any ATM port. Activate
ILMI on a port to perform any of the following tasks:
• Use ILMI automatic configuration, which negotiates ATM communication parameters
• Use ILMI address registration, which negotiates an ATM address for an attached CPE using an
ILMI prefix assigned to a port
• Enable CWM auto-discovery on a link, which allows CWM to search for and discover
Cisco switches that it can manage
• Create a PNNI link to a BXM card on a Cisco BPX