Specifications

3-45
Cisco ATM Services (AXSM) Configuration Guide and Command Reference for MGX Switches
Release 5.2, Part Number OL-6484-01 Rev. C0, September 2005
Chapter 3 Provisioning ATM Services
General AXSM Configuration Procedures
Type #Svcc: #Svpc: #SpvcD: #SpvpD: #SpvcR: #SpvpR: #Total:
p2p: 0 0 0 0 0 0 0
p2mp: 0 0 0 0 0 0 0
Total=0
Summary of total configured SPVC endpoints
Type #SpvcCfg: #SpvpCfg:
p2p: 1 0
p2mp: 0 0
Per-port status summary
PortId IF status Admin status ILMI state #Conns
7.35 up up Undefined 0
7.36 up up Undefined 0
7.37 up up Undefined 0
7.38 up up Undefined 0
Type <CR> to continue, Q<CR> to stop:
1:1.1:1 down down Disable 0
2:2.2:1 up up Disable 0
Step 5 To select the port signaling protocol, enter the following command:
cnfpnportsig <portid> < [-univer {uni30|uni31|uni40|q2931|none|self}]
[-nniver {iisp30|iisp31|pnni10|enni|aini}] [-unitype {public|private}]
[-addrplan {both|aesa|e164}] [-side {user|network}] [-vpi <vpi>]
[-sigvci <signalling-vci>] [-rccvci <routing-vci>] [-cntlvc {ip}]
[-passalongcap {enable|disable}] [-hopcntgen {enable|disable}]
[-vpivcialloc {enable|disable}] [-svcroutingpri <svcroutingPriority>] >
The only required parameter for this command is the <portid> parameter, but the command serves no
purpose if you do not enter at least one option with it. If you include some options with the command
and omit others, the omitted option remains set to the last configured value.
Tip With some commands, you can refer to a port using only the interface number, while other
commands require you to enter a complete port identification number, which includes the slot,
bay, line, and interface numbers. For example, when entering commands at the PXM switch
prompt, you always need to specify the complete port identification number. When entering
commands at the AXSM card prompt, you can enter only the interface number, because the
interface number is unique on the card and identifies the slot, bay, and line for the port.
Note The selection of UNI or NNI is made when the port is added with the addport command. You
cannot use the -univer and -nniver options to change the port type.
The following example illustrates how to configure an NNI port to use PNNI Version 1.0 signaling.
MGX8850.7.PXM.a > cnfpnportsig 1:1.1:1 -nniver pnni10
Step 6 Enter the cnfoamsegep command to define the local routing switch feeder port as a non-OAM segment
endpoint:
MGX8850.7.PXM.a > cnfoamsegep <portid>